Glass lined reactor scrapping principle

　　The use of any equipment are scrapped, so the use of glass-lined reactor is no exception, but in the use of glass-lined reactor, to correctly determine the standard of equipment scrapped, but also in accordance with the requirements of the provisions of the requirements, so as to ensure that the use of equipment safety.

　　1, first of all, according to the kettle body wall thickness uniform corrosion degree to judge, because the equipment in the just purchased will be accompanied by a manual, if the thickness of the manual than the limit value of the stipulation of the time, it is necessary to carry out the replacement, there is also because of the equipment for the operation of a lot of materials are corrosive, so if the equipment corrosion area is also more than the instruction manual Limit value is also the need for replacement.

　　2, when the equipment has some serious defects can also be judged to be scrapped, of course, according to the defects of the judgment of scrapped when you need to make sure that because of the defects and can not meet the normal operation of the glass-lined reactor and is no possibility of repair.

　　3, because of alkali brittle and other more serious corrosion can be applied for scrapping, and kettle body cracks and can not be repaired when it is necessary to replace the new equipment.

　　4, in the hydrostatic test found that the equipment deformation is serious when it shows that the equipment can not be used normally. Above is to judge the glass lined reactor scrapping method, we usually use must not wait until the process of running suddenly replaced and then replaced, so that in the reactor inside the materials are wasted, so we are in the equipment is about to be scrapped in time for the replacement, but also can be avoided to cause some economic losses.

　　Strictly in accordance with the principle of glass lined reactor scrapping equipment judgment, better guarantee the operation of the equipment, and the use of efficiency, and, in the use of the process to extend its service life, the need for regular equipment inspection and maintenance, so as to ensure that the equipment is used.